Pharmacy Refrigerator REF-500

• Avoiding Injury :
• Review safety
• using, or maintaining the equipment.
• Do not open multiple, loaded Drawers .
• Do not move a unit (single-door units)  .
• Before moving unit, ensure casters are unlocked and free of debris.
• Never physically restrict any moving component.
• Avoid removing electrical service panels and access panels unless so instructed.
• Use manufacturer supplied power cords only.
• CAUTION.:
• Decontaminate parts prior to sending for service or repair. Contact TRUST-EG or our distributor for decontamination instructions and a Return model and serial Number.
• Trust-EG refrigerators are intended for the storage of drug products and other medical and scientific products.
• General Use .
• Allow refrigerator to come to room temperature and open the door before switching power on.
• During initial startup, high temperature alarm may sound while refrigerator reaches operating temperature.
• CAUTION : Do not remove the cover from the condensate evaporator tray.

• Initial Loading :
• Allow the refrigerator to reach room temperature before powering on. Allow chamber temperature to stabilize at the set point before storing product.

• Product Loading Guidelines.:
• When loading your refrigerator, take care to observe the following guidelines:
• Never load refrigerators beyond capacity.
• Always store items within drawers or baskets.
• Temperature uniformity is maintained by air circulation, which could be impeded if unit is overfilled, particularly at the top or back. Ensure proper clearance is provided below the fan.

Note

• Products stacked against back wall may obstruct air flow and affect performance of unit.

• Installation
• Location:
• Has a grounded outlet meeting the electrical requirements listed on the product specification label.
• Is clear of direct sunlight, high temperature sources, and heating and air conditioning vents.
• Meets limits specified for ambient temperature (4˚C to 45˚C) and relative humidity.

• Placement and Leveling :
• CAUTIONS :
• The evaporation tray located on the rear of the refrigerator may be hot. Do not use the tray as a handle.
• To prevent tipping, ensure the casters are unlocked, leveling feet (if installed) are lifted, and the doors are closed before moving the refrigerator.
• Roll refrigerator into place and lock casters.
• Ensure refrigerator is level.

• Temperature Probes :
• Probe bottle(s) along with a container of glycerin have been provided with this unit. The glycerin is used to create a solution which simulates the product stored in the refrigerator. The product simulation solution temperature reflects the product’s temperature during normal operation.

• Primary Monitor Probe :
• The remote monitor probe is located in the top right corner of the refrigerator.

• Primary monitor probe with monitoring Remote system

Operation :                                                                                                                                                                                                                 

• Initial Power-Up.:

• Plug the power cord into a grounded outlet that meets the electrical requirements on the product specification label.
• Turn the AC power switch ON.
• Turn the Back Up battery switch ON.
• TOUCH SETTING ON SCREEN as shown in the figure (1) .
• To enter the settings of the device, touch the settings tab and enter the password as shown in the figure (2) .
• Choose the operating temperature and separation temperature via the arrows as shown in the figure(3)
• Touch the word save twice.
• Touch the back sign.

Note:

• Active alarms are displayed on the Home screen. If an alarm condition other than High Temperature occurs, wait to access set point.

• After about 30 minutes have passed, the unit will reach the required degree that was set in advance, and then the system will draw a graph of the heat and the disappearance of the audio alarms and messages written on the screen As shown in the two figures.

   Change Temperature Set point:

 Voice alerts and messages on the screen:

(1) if you press it explain our Company profile.

(2) if you press it mute voice or un mute.

(3) if you press it setting program.

(4) explain Low or High Temp.

(5) explain Door open or close.

(6) explain Compressor Failure (that’s problem on you compressor check it ).